Power Connector Cable - HP Pavilion x360 Convertible PC Maintenance And Service Manual

Power connector cable

Table 5-7 Power connector cable description and spare part number information
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the solid-state drive (see
Remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Release the power connector cable from the retention clips (2) built into the keyboard/top cover.
3. Remove the two Phillips M2.5×5.7 screws (3) that secure the display right hinge to the keyboard/top cover.
4. Swing the display right hinge (4) up and back.
5. Remove the power connector cable (5).
Reverse this procedure to install the power connector cable.
32 Chapter 5 Removal and replacement procedures
Bottom cover on page 23).
Solid-state drive on page
Battery on page 25).
29).
Spare part number
L52064-001