Health O Meter 500HB Installation Instructions Manual page 3

Mounting Handlebars on New, Unassembled Scales
Refer to the scale's user manual for
assembly instructions. In step 8 of the
scale assembly, do not completely insert
all 4 screws. Partially insert only the two
screws closest to the scale column,
leaving ¾" of the screws exposed. Then
skip to step 5 on the following page.
Mounting Handlebars on Assembled Scales
1. Gently place the scale on a flat, level
surface on its side.
2. Remove the 2 Rear Screws (closest to
the wheels) that secure the Scale
Column to the Base.
3. Loosen but DO NOT REMOVE the 2
Forward Screws (closest to the scale
base). Loosen Screws approximately
¾". Note, the Load Cell Cable does not
need to be removed.
4. Loosen Screws approximately ¾".
P/N 82-00009 REV A 500HB Installation Instructions REV20200402_web
Loosen Screws
3
Leave ¾"
of the
screws
exposed
Loosen
Screws ¾"