Fan - HP Chromebox G3 Maintenance And Service Manual

3. Remove the four Phillips M2.5 × 5.0 screws that secure the system board to the top cover.
4. Lift the rear edge of the system board (1) until it rests at an angle.
5. Remove the system board (2) by sliding it forward at an angle.
Reverse this procedure to install the system board.

Fan

To remove the fan, use these procedures and illustrations.
Table 6-9 Fan description and part number
Description
Fan (includes cable)
Before removing the fan, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
ENWW
(Preparation for disassembly on page
(Bottom cover on page 27), and then remove the following components:
Spare part number
M24727-001
27).
Component replacement procedures 37