1.
Prepare the Chromebox for disassembly
2.
Remove the bottom cover
3.
Remove the I/O side frame
4.
Remove the bottom shield
When you replace the system board, be sure to remove the following components from the defective system
board and install them on the replacement system board:
WLAN module (see
●
Solid-state drive (see
●
●
Memory module and shield (see
Fan (see
●
Heat sink (see
●
Remove the system board:
1.
Disconnect the WLAN antenna cables (1) from the WLAN module terminals.
NOTE:
WLAN antenna cable connects to the WLAN module #2/Aux terminal.
2.
Disconnect the power button board cable (2) from the system board.
36
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
(I/O side frame on page
(Bottom shield on page
WLAN module on page
Solid-state drive on page
Memory module on page
Fan on page
37)
Heat sink on page
38)
The #1/Main WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/Aux
(Preparation for disassembly on page
27).
28).
29).
31)
33)
33)
27).
ENWW