Power Connector Cable - HP Chromebox G3 Maintenance And Service Manual

4. Disconnect the power connector cable from the system board connector (5).
5. Remove the bottom shield.
To replace the bottom shield, reverse the removal procedures.

Power connector cable

To remove the power connector cable, use these procedures and illustrations.
Table 6-4 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
3. Remove the I/O side frame
4. Remove the bottom shield
Remove the power connector cable:
1. Turn the bottom shield right side up with the rear panel toward you.
2. Remove the two Phillips M2.5 × 5.0 screws (1) that secure the power connector cable to the bottom shield.
3. Remove the power connector cable bracket (2).
The power connector cable bracket is available using spare part number M42090-001.
4. Remove the power connector cable (3).
30 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 27).
(I/O side frame on page 28).
(Bottom shield on page 29).
Spare part number
L17259-001
27).
ENWW