Preparation For Disassembly; Bottom Cover - HP Chromebox G3 Maintenance And Service Manual

Preparation for disassembly

Bottom cover

To remove the bottom cover, use this procedure and illustration.
Table 6-1 Bottom cover description and part number
Description
Bottom cover
Before removing the bottom cover, prepare the Chromebox for disassembly
on page 27).
Remove the bottom cover:
1. Position the Chromebox upside down with the rear toward you.
2. Remove the four rubber feet (1).
The rubber feet are available in the Rubber Feet Kit, spare part number L17271-001.
3. Remove the four Phillips M2.5 × 5.0 screws (2) that secure the bottom cover to the Chromebox.
4. Use a case utility tool or similar thin plastic tool (1) to separate the front edge of the bottom cover (2) from
the Chromebox.
ENWW
Spare part number
L17258-001
(Preparation for disassembly
Component replacement procedures 27