Display Assembly - HP OMEN 16 Maintenance And Service Manual

Table 5-16 RJ-45 door description and part number
Description
RJ-45 door for use in 60 W models
RJ-45 door for use in 80 W models
Before removing the RJ-45 door, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the heat sink (see
6. Remove the fans (see
7. Remove the system board (see
Remove the RJ-45 door:
From the inside of the computer, insert a flat tool under the RJ-45 door (1), and then lift the door up to
▲
remove it (2).
Reverse this procedure to install the RJ-45 door.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE: The display assembly is available as a spare part only at the subcomponent level. For display
assembly spare part information, see the individual removal subsections.
Before removing the display panel, follow these steps:
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Solid-state drive on page
Heat sink on page 38).
Fans on page 40).
System board on page
30).
33).
44).
Spare part number
M57166-001
M75828-001
30).