Touchpad - HP OMEN 16 Maintenance And Service Manual

1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure the card reader to the computer.
2. Remove the card reader from the computer (2).
Reverse this procedure to install the card reader.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-15 Touchpad description and part number
Description
Touchpad
Touchpad cable
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
Remove the touchpad:
1. Remove the four Phillips M2.0 × 2.5 screws (1) from the touchpad bracket, and then remove the bracket
from the computer (2).
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Solid-state drive on page
Power connector cable on page
Heat sink on page 38).
Fans on page 40).
System board on page
30).
33).
37).
44).
Spare part number
M57156-001
M57157-001
30).