Ir Sensor Board - HP OMEN 16 Maintenance And Service Manual

IR sensor board

To remove the IR sensor board, use this procedure and illustration.
Table 5-12 IR sensor board description and part number
Description
IR sensor board
IR sensor board cable
Before removing the IR sensor board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
Remove the IR sensor board:
1. Remove the protective tape from the board (1).
2. Remove the Phillips M2.0 × 2.5 screw (2) that secures the board to the computer.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Solid-state drive on page
Power connector cable on page
Heat sink on page 38).
Fans on page 40).
System board on page
30).
30).
33).
37).
44).
Component replacement procedures
Spare part number
M57152-001
M57153-001
47