1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the left solid-state drive (see
5.
Remove the heat sink (see
Remove the WLAN module:
1.
Remove the plastic antenna protector from the module (1).
2.
Carefully disconnect the antenna cables from the module (2).
3.
Remove the Phillips M2.0 × 2.5 screw (3), and then remove the WLAN module from the computer (4).
NOTE:
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable
connects to the WLAN module #1 Aux terminal.
42
Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
Heat sink on page
Models have either one or two WLAN antennas. On models with two antennas, the #1 white
Preparation for disassembly on page
30).
31).
Solid-state drive on page
38).
30).
33).