Wlan Module - HP OMEN 16 Maintenance And Service Manual

4. Remove the solid-state drives (see
5. Remove the heat sink (see
Remove the fans:
1. Remove the two Phillips M2.0 × 5.0 screws (1) from the right fan and three Phillips M2.0 × 5.0 screws (1)
from the left fan.
2. Disconnect the fan cables from the system board (2).
3. Remove the fans from the computer (3).
Reverse this procedure to install the fans.

WLAN module

To remove the WLAN module, use this procedure and illustration.
Table 5-9 WLAN module descriptions and part numbers
Description
Realtek Wi-Fi 6 RTL8852AE + Bluetooth 5.2 (802.11ax 2 × 2))
Intel Wi-Fi 6 AX210 + Bluetooth 5.2 (non-vPro)
WLAN module protective shielding
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
Heat sink on page
To prevent an unresponsive system, replace the wireless module only with a wireless module
Solid-state drive on page
38).
33).
Spare part number
M27269-005
M34029-005
M14330-001
Component replacement procedures 41