Fans - HP OMEN 16 Maintenance And Service Manual

apply thermal gel are noted by small square brackets in white on the board. (3) Reinstall the
thermal module onto the system board.
5. (Models with Ryzen 9 processors) If you remove the heat sink from the system board, when replacing
the heat sink you must place thermal grease onto the integrated processor on the system board in a 10
mm × 9 mm area as shown in the following illustration. Be sure not to apply too much or too little
thermal grease. Thermal grease specific to Ryzen 9 processors is available as spare part number
M81610-001.
NOTE:
For specific information about correctly applying thermal gel, go to
16.1 inch Gaming Laptop PCs - Power Shortage May Occur When Excess Grease Overflows Onto SMD
Components Around AMD CPU Die.
Reverse this procedure to install the heat sink.

Fans

To remove the fans, use this procedure and illustration.
Table 5-8 Fans description and part number
Description
Fan, 80 W
Fan, 60 W
Before removing the fans, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Authorized service agents only
Bottom cover on page
Battery on page
Preparation for disassembly on page
30).
31).
WISE and search for OMEN 16-c0000
Spare part number
M57161-001
M57160-001
30).