Notes For Remote Zone Panel - Immergas System Manager Kit Instructions And Warnings

Function lock. In conjunction with the activation of the
time slots, the manual room temperature control mode
is disabled; this status is signalled by the activation of the
relative symbol " ".
Room temperature manual adjustment. In the event the
time slots are not used, one can set the room temperature
simply by turning the main selector.
Once the required room temperature is set, the display
will go back to showing the measured room temperature.
Room humidity adjustment. To display the humidity
in the room, press the main selector, during the display
of the humidity one can change the desired humidity
value, simply by turning the main selector.
By pressing the new selector, the zone flow set and the
system active dhw set can be displayed.
Anomalies display. In the event there is an anomaly in
progress, the remote control displays the status via the
symbol " ".
7.3

NOTES FOR REMOTE ZONE PANEL

Fig. 7-9
Please refer to the relevant instructions sheet for instal-
lation instructions. The required addresses to use are:
41 = Zone 1
42 = Zone 2
43 = Zone 3
44 =
If using the remote panel you can configure the following
parameters also via the panel:
- time slots calendars
- room set-point of relative zone
After configuring a remote panel the system must be
reset.
Fig. 7-10
47
Zone AT
Fig. 7-11