Immergas System Manager Kit Instructions And Warnings page 23

S y s t e m d e f i n i t i o n
Zone 01: HEAT
Zone name:
Comm: No
Fig. 5-7
- Zone 01. Hot, cold, hot/cold.
- Zone disp. Absent, Rem. control, Remote panel, Zone
control, Temp-humid probe
N.B.: When there is only one fixed zone it is not possible
to use the temperature/humidity probes but only the zone
control or ON/OFF inlet for this zone.
N.B.: For each zone it is possible to configure:
- zone name (max 10 characters).
- possible presence of zone control (Yes / No). If the
zone control is disabled you will be requested to enable
the room probe (temperature and humidity probe).
S y s t e m d e f i n i t i o n
Zone 01: HEAT
Thermostat: No
Humidostat: No
Dewpoint: No
En.dehum.: No
Fig. 5-8
- Enabling room thermostat (Yes / No). In the event
of absence of zone device and zone probes, the room
thermostat is automatically enabled.
- enabling humidistat (Yes / No).
- Enabling dew point calculation (intended to elimi-
nate any formation of condensation) (Yes / No). This
option is not included in the high temperature zone.
- Enabling dehumidifier (Yes / No). This option is not
included in the high temperature zone.
Using the screen shown here below it is possible to choose
P 0 2
which zone will be displayed in the user's main menu.
S y s t e m
Main zone: Z01
Sitting room
Fig. 5-9
The screen shown below allows to choose the model for
the heat pump used (max. 4).
System definition
Heat pumps: 4
P 0 3
Fig. 5-10
N.B.: Select "Audax 2017" in the case of "Audax Top
18/21 ErP". The power of the machine is automatically
detected by the system
The screen shown here below allows you to enable the
presence of the solar circuit and the number of pumps
included in this circuit.
S y s t e m
Solar system
Num. pumps: ----
(Solar disabled)
Fig. 5-11
N.B.: If the solar circuit is enabled it is also possible to
enable the solar integration for heating function (puffer).
23
d e f i n i t i o n
Audax Top 6
Audax Top 12
Audax Top 8
Audax Top 6
d e f i n i t i o n
P 0 9
P10
P 1 1