Table of Contents
Advertisement
1.4.3 Operation in summer mode with cooling
Pressing button
with cooling: the "System Manager Kit" enables both
domestic hot water production and room cooling (see
Fig. 1-7). The display shows current day and time, any
operating faults, ambient temperature and humidity
percentage in the main area.
N.B.: press arrows
for any other stored areas.
08:50
VE
Sitting room
T:
00.0 °C
U:
00.0 %
Fig. 1-7
The "System Manager Kit" allows automatic functioning
in cooling mode, in which a time program manages the
room temperature during the hours of the day.
The desired room temperature can be adjusted onto
two independent levels: comfort (
(
). The distribution of these levels throughout the
day or week is controlled by the hourly programming
(see Paragraph 2.3).
The "System Manager Kit" is factory set as shown in
the table below. If this should not satisfy requirements,
it is possible to modify it as described in the following
chapters.
Days
Mon-Fri
Sat-Sun
N.B.: the system is designed to function on comfort
and reduced temperature levels depending on the hour
program set. Therefore also during functioning in re-
duced room temperature conditions, if the temperature
measured is above that set, the system can switch-on.
switches to summer operation
to view the same parameters
10/06/11
M01
) and reduced
28°C
25°C
-
0 ÷ 24
-
0 ÷ 24
1.4.4 Operation in winter mode
Pressing button
the "System Manager Kit" enables both domestic hot
water production and room central heating (see Fig. 1-8).
The display shows current day and time, any operating
faults, ambient temperature and humidity percentage
in the main area.
N.B.: press arrows
for any other stored areas.
08:50
VE
Sitting room
T:
00.0 °C
U:
00.0 %
Fig. 1-8
The "System Manager Kit" allows automatic functioning
in central heating mode, in which a time program man-
ages the room temperature during the hours of the day.
The desired room temperature can be adjusted onto
two independent levels: comfort (
(
). The distribution of these levels throughout the
day or week is controlled by the hourly programming
(see Paragraph 2.3).
The "System Manager Kit" is factory set as shown in
the table below. If this should not satisfy requirements,
it is possible to modify it as described in the following
chapters.
Days
Mon-Fri
Sat-Sun
N.B.: the system is designed to function on comfort
and reduced temperature levels depending on the hour
program set. Therefore also during functioning in re-
duced temperature conditions, if the room temperature
measured is below that set, the system can switch-on.
10
switches to winter operation:
to view the same parameters
10/06/11
M01
) and reduced
16°C
20°C
-
0 ÷ 24
-
0 ÷ 24
Advertisement
Table of Contents
