Safety Precautions; Loop Lock Operation - Drive 10257BL-1 Manual

assembly instructions
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton.
2. Open frame and slide padded backrest into frame
brackets making sure snap bottoms protrude
through holes.
3. Remove packaging caps on handle receptacle and
insert handle tube into frame. The brake cable should
be positioned on outside of frame. Set handle to
desired height. Insert bolt into the clamp from the
inside of the frame. Next slide the washer on the bolt
from the outside of the frame. Next attach tightening
knob to the bolt and turn clockwise until secure.
Make sure both handles are set to the same height
before use.
Hand Grips
Backrest
Height
Adjustable
Folding
Hinge for
Portability
WEIGHT CAPACITY 300 LBS (136 KG)
Orthodic
Loop Locks
Safest System
Available
Comfortable
Seat
1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from rolling. If the wheels
roll while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should roll freely.
4. Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.
Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a Temporary Stop—Pull
up slowly on the loop locks with four fingers until unit
slows down or comes to a temporary stop.
2. To Temporarily Lock Wheels in Position—Press down
Storage bag
on both loop locks with palms until you hear a "click"
for Functionality
& Storage
that will tell you wheels are locked.
3. To Release Wheel Locks—Pull up on both loop locks
with palms of hand to original position.

safety precautions

Important Safety Notice

loop lock operation