Immergas VICTRIX PRO 35 1 I Instruction For Technician And Installer page 8

BUS address entry in the zone manager.
- First start-up.
After completing the installation and starting up
the system, all available segments are visualized
on the zone manager display.
000000000000
Segment test
00:00:0 00:00
6 6 6 6 66 6 6
Soon after the instrument identification and the
bus address are visualized.
Instrument identification
THETR RS
Type of instrument
Software date
11:02
V 1.0
Software version
Address input
BUS address
see scheme above
- 1 1
After the bus address input and confirmation,
pressing the knob, automatically the associated
heating circuit is visualized:
bus dati
Data bus address
Direct circuit
cd
ac --1
Main regulator
Attention:
Double assignments of the same data bus address
cause errors during the data transmission and
faults of system adjustments.
- Bus address change.
To change a bus address, it's necessary to follow
the procedures below :
1 - to cut off the bus data cable from the zone
Manager
2 - to fix again the zone Manager pressing the
turnable knob till the bus address is visua-
lized.
3 - to insert the new bus address and confirm.
Page 8