Immergas BASIC MAGIS PRO Instructions And Warnings page 58

Magis Combo Plus V2 Indoor Unit installation
operations.
Install the Magis Combo Plus V2 by using the
additional kit for coupling Magis Combo Plus
V2 to Basic Magis Pro supplied as an optional
(Ref. W Fig. 16).
• Discard the indicated components (Ref. Y Fig.
16) from the "Basic Magis Pro accessory unit"
and use those in the optional additional Kit and
supplied in the connection unit of the Magis
Combo Plus V2 Indoor Unit (Ref. W Fig. 16).
G
Basic Magis Pro for coupling to Magis Combo Plus.
Y
• Tighten the bracket (e) to the special upper
cross member with screws (f).
• Hang the indoor unit (G) on the bracket (e)
installed previously, (Fig. 15).
• Remove the by-pass pipe between the storage
tank unit flow and return (MU-RU) from the
indoor unit and make the hydraulic connection
between the Storage Tank Unit (a), Single-zone
hydraulic unit (c) and Magis Combo Plus V2
Indoor Unit (G), as shown in Fig. 17 and 18.
e
1
f
2
58
Perform the connections in sequence, starting
from the pipes near the rear wall up to those near
the installer, remembering to insert the special
gaskets supplied.
Assemble the DHW probe (Fig. 17) by inserting
it in the specific seat.
N.B.(Fig. 18): disassemble the grid and the
square gas cock from the Magis Combo Plus
V2 Indoor Unit. Turn the shut-off valves on the
Magis Combo Plus V2 return by 40° to connect
it to the relative pipe in the accessory kit.
1
f
2
W
15
G
16