Immergas BASIC MAGIS PRO Instructions And Warnings page 57

Magis Pro V2 Indoor Unit installation op-
erations.
• Tighten the bracket (e) to the special upper
cross member with screws (f).
• Hang the indoor unit (P) on the bracket (e)
installed previously, (Fig. 13).
• Remove the by-pass pipe between the
storage tank unit flow and return (MU-
RU) from the indoor unit and make the
hydraulic connection between the Storage
P
Tank Unit (a), Single-zone hydraulic unit (c)
and Magis Pro V2 Indoor Unit (P), as shown
in Fig. 14.
• Perform the connections in sequence, starting
from the pipes near the rear wall up to those
near the installer, remembering to insert the
special gaskets supplied.
N.B.: the Magis Pro V2 Indoor Unit is supplied
with an interception cock to be placed on the
e
1
f
2
2
1
system flow; use the cock on the Basic Magis Pro
connection unit.
Attention: in this installation it is essential to
leave the cap on the storage tank unit return
fitting of the indoor unit mounted.
The DHW probe (Fig. 14) is to be inserted in the
specific seat "1" (Ref. 17 Fig. 36) when the DHW
electrical resistance is not present.
Vice versa, it must be inserted in seat "2"
(Ref. 10 Fig. 36).
1
f
2
AC
MU
a
MU
RU
57
13
P
P
R
AF
M
GP
LP
c
AF
14