Set Output Interval - Vaisala CARBOCAP GMW90 Series User Manual

Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 49

Set Output Interval

Use the INTV command to change the output interval of the
automatically repeating measurement messages. The measurement
messages are repeated in the RUN mode, or after the R command has
been given.
INTV [n xxx]<cr>
where
n = time interval, range 0 ... 9999.
xxx = time unit = "S", "MIN", or "H"
The shortest output interval (with n = 0) outputs the measurement
messages as quickly as the transmitter produces them, without additional
delay.
Example:
>intv 1 min
Output interval : 1 min