Chapter 4 _________________________________________________________________ Operation
NOTE
VAISALA ________________________________________________________________________ 41
Show Measured Parameters
Use the CALCS command to list the measurement parameters that are
supported by the GMW90 series transmitters. CO
measured directly by the transmitter, the rest are calculated based on the
measured values.
CALCS<cr>
Example:
>calcs
RH
- Relative Humidity
T
- Temperature
Tdf
- Dew/Frost point temperature
Td
- Dew point temperature
Tw
- Wetbulb temperature
h
- Enthalpy
x
- Mixing ratio
a
- Absolute humidity
dTd
- Dew/frostpoint depression
CO2
- Filtered CO2
CALCS command also lists all humidity parameters, even if your
transmitter model does not measure humidity.
Show Command Help
To see a short description of an individual command, issue the command
with a question mark as a parameter.
Example:
>calcs ?
Display measured quantities
, RH and T are
2