Figure 4 Transmitter Parts - Inside - Vaisala CARBOCAP GMW90 Series User Manual

Chapter 2 ___________________________________________________________ Product Overview
2
3
4
5
VAISALA ________________________________________________________________________ 17
1
Figure 4 Transmitter Parts – Inside
1 = Mounting base.
2 = Opening for cable (wiring from top).
3 = Terminal label.
4 = Opening for cable (wiring from behind, recommended).
5 = Label for RS-485 baud rate DIP switch settings.
Included only on digital models.
6 = Orientation arrow – should point up after the mounting base has
been installed.
7 = Screw terminals.
8 = Place for zip tie (for cable strain relief)
9 = Transmitter body.
10 = RS-485 termination jumper (connects a 120 Ω resistor).
Included only on digital models.
11 = GM10 module (measures CO
12 = DIP switches for common configuration options. Digital models
have an extra DIP switch bank for transmitter address.
13 = Grip for slide.
14 = TM10 module (measures temperature only) or
HTM10 module (measures humidity and temperature).
®
15 = HUMICAP
6
7
8
12
).
2
sensor (on models with humidity measurement).
9
14 15
10
11
13
1310-039