Coast to Coast Winegard ConnecT 2.0 Operation Manual page 3

OPERATION (WiFi)
5) To connect to a WiFi network, select WiFi ONLY and then click on SCAN
FOR WiFi. See figure 3.This will bring up a list of all WiFi signals in
range (this could take a few minutes). The Winegard ConnecT 2.0 will
display available networks by signal strength. Select the desired network
and click CONTINUE. See figure 4.
6) Enter the network password, if prompted. Once the Winegard ConnecT
connects to the internet the INTERNET STATUS will show connected (this
could take as long as two minutes). You are now ready to use the WiFi.
INSTALLING THE SIM CARD FOR 4G USE
NOTE: In order to update the ConnecT 2.0's firmware with the correct Carriers Network
Settings you will need an internet connection. Please make sure that you have a usable
WiFi connection.
The Winegard ConnecT 2.0 works with most Australian cellular providers.
Once you have selected the cellular provider of your choice, you will
need to insert an approved SIM card (Mini-SIM/Standard SIM – 25mm
x 15mm x 0.76mm). You will also need the correct APN (Access Point
Name) linked to the SIM card.
Once you have the SIM card from your cellular provider, you are ready to
install the SIM. In order to do this, follow these instructions:
1) Start with the ConnecT 2.0 powered off.
2) Remove the 2 Phillips head screws that attach to the SIM card cover
plate.
3) Remove the SIM card cover plate.
4) Take your newly acquired SIM card and insert it into the empty SIM
card holder, with the metal electronic chip facing downward. You should
hear a clicking sound once the card inserts into the correct position. DO
NOT force the SIM card in to the SIM holder. The card must be properly
positioned to function. If you do not hear a clicking sound, make sure that
the SIM card is inserted correctly. If it is inserted backwards it will not
insert completely and you will not hear a clicking sound.
5) Replace the SIM card cover plate and 2 screws.
SIM Card
Reset Button
LED
Figure 3
Figure 4
NOTE: When using your own private data plan
some features will be unavailable, such as the
Data Plan page. For information about data usage,
contact your cellular provider.
NOTE:
After you have successfully swapped your
SIM card, you will need to update the software of the
ConnecT to recognize the SIM that is now installed.
2