Associating App To Smartech Plus - Immergas SMARTECH PLUS Instructions And Warnings

1.3 ASSOCIATING APP TO SMARTECH PLUS.

N.B.: before this, make sure you have the password and the Wi-Fi network
you want to connect to and make sure that this network has an Internet
connection. Do not use a hotspot when associating the app.
Make sure that your Smartphone is connected to this network.
• power the Gateway and check that the batteries have been inserted in
the chrono-thermostat, wait a couple of minutes;
• quickly press the "Reset" button 5 times. The "Cloud" and "Ble" LEDs
will light up together;
• the Gateway turns off and on again;
• when the two LEDs "Cloud" and "Ble" flash together once per second,
the Gateway is in Smartech_config_AP mode.
N.B.: if you have already connected the Gateway to your account, but want
to change the Wi-Fi connection to which you are connected, simply repeat
the 4 points above. Then select one of the Chrono-thermostats associated
to the Gateway you want to reconfigure by changing the password through
the App, select "Configuration", "WIFI NETWORK CONNECTED" and
press "UPDATE". Select "Smartech_config_AP" and choose the network
which you want to connect the Gateway to.
Open the "Smartech" App, login, the message "No device has yet been
added" will appear, press "+" at the bottom right. Execute the displayed
requests and select "Smartech_config_AP".
3
4
• Select the generator model from the proposed list (Fig. 5). The name
is shown on the generator control panel (see example Fig. 6) or on the
data nameplate (Ref. 1, Fig. 12).
5
5