Table of Contents
Advertisement
8. Adjust the input pressure until the altimeter is exactly reading a 1000 foot
mark.Note the difference between the digitizer and the altimeter and adjust
as required.
Example:
The altimeter reads 10,000 and the digitizer reads 10,080.
Type "S10 <enter>"
(S10 represents Set 10,000feet)
The digitizer will now output 10,000 feet based on the current input pressure.
The PC will display the altitude at which the digitizer will make this change.
In the example above the PC would display >10000.
9. Proceed to the next 1000 foot mark and repeat the procedure, as in step 8
above,until the entire operating range of the digitizer is completed.
(Note: If no correction is required at an altitude simply do not enter a
correction. The
technician does not have to enter 000.).
(Note: If no correction is required at an altitude simply do not enter a correction. The
technician does not have to enter 000.)
-19-
Advertisement
Table of Contents
