Table of Contents
Advertisement
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Disconnect the antenna cables from the integrated WLAN module (1), and then remove the cable from
its routing path along the top of the computer (2).
2.
Disconnect the camera cable from the system board (3).
3.
Disconnect the display cable from the system board (4), and then remove the cable from the clips next
to the left hinge (5).
4.
Remove the four Phillips M2.5 × 6.0 screws (1) that secure the display to the computer.
5.
Open the computer to open the hinges (2).
6.
Separate the display from the computer (3).
7.
If you need to remove the display panel:
34
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
23).
23).
Battery on page
24).
Advertisement
Table of Contents
