Touchpad - HP ENVY x360 15m Maintenance And Service Manual

Remove the touchpad cable:
1. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
3. Detach the touchpad cable (3) from the top cover/keyboard. (The touchpad cable is attached to the top
cover/keyboard with double-sided adhesive.)
4. Remove the touchpad cable (4).
Reverse this procedure to install the touchpad cable

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-13 Touchpad description and part numbers
Description
Touchpad
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The touchpad
bracket is not available as a spare part component. The touchpad cable is available using spare part number
M45458-001.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad:
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
29).
Spare part number
M45480-001
29).
Touchpad 53