Touchpad Cable - HP ENVY x360 15m Maintenance And Service Manual

Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the solid-state drive (see
5. Remove the processor fan (see
6. Remove the graphics fan (see
7. Remove the heat sink (see
8. Remove the system board (see
Remove the power connector cable:
1. Remove the three Phillips M2.5 × 4.9 screws (1) that secure the display right hinge to the computer.
2. Swing the display right hinge (2) up and away from the computer.
3. Release the power connector cable from the retention clips (3) and routing channel built into the top
cover/keyboard.
4. Remove the power connector cable (4).
Reverse this procedure to install the power connector cable.

Touchpad cable

To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is available using spare part number M45458-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Solid-state drive on page
Processor fan on page
Graphics fan on page
Heat sink on page 42).
System board on page
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
29).
Battery on page 31).
33).
40).
41).
43).
29).
29).
29).