Display Assembly - HP 17-cn0 Series Maintenance And Service Manual

1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the WLAN module (see
5. Remove the solid-state drive (see
6. Remove the fan (see
7. Remove the system board (see
Remove the speakers:
1. Lift the protective tape that covers the cable between the speakers (1).
2. Use a tool to release both speakers (2). The speakers are secured with adhesive.
3. Remove the speakers from the computer (3) .
Reverse this procedure to install the speakers.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the display assembly:
1. Disconnect the display cable from the system board ZIF connector (1), and then remove the tape that
secures the display cable to the system board (2).
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 34).
WLAN module on page
Solid-state drive on page
Fan on page 44).
System board on page
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 34).
32).
38).
37).
48).
32).
Component replacement procedures
32).
32).
51