HP 17-cn0 Series Maintenance And Service Manual page 51

1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad:
1. Remove the three Phillips M2.0.× 2.0 screws (1) that secure the touchpad bracket to the computer.
2. Remove the bracket from the computer (2).
3. Disconnect the cable from the ZIF connector on the touchpad module (1).
4. Remove the three Phillips M2.0 × 2.0 screws (2) that secure the touchpad to the computer.
5. Remove the touchpad from the computer (3).
Reverse this procedure to install the touchpad.
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 34).
32).
32).
Component replacement procedures 43