Touchpad - HP 17-cn0 Series Maintenance And Service Manual

Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the USB board:
1. Remove the two Phillips M2.0 × 4.0 screws (1) that secure the USB board to the computer.
2. Lift the board up and turn it over to access the cable connected to the bottom (2).
3. Disconnect the cable from the ZIF connector on the bottom of the board (3).
Reverse this procedure to install the USB board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-9 Touchpad description and part number
Description
Touchpad, jet black
Touchpad, evening blue
Touchpad, natural silver
Touchpad, snowflake white
Touchpad, opulent aubergine
Touchpad, underwater teal
Touchpad cable
Before removing the touchpad, follow these steps:
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 34).
32).
32).
Spare part number
M50414-001
M50415-001
M50416-001
M50417-001
M59354-001
M59355-001
M50423-001