Usb Board - HP 17-cn0 Series Maintenance And Service Manual

Table 5-7 Fingerprint reader description and part number (continued)
Description
Fingerprint reader, underwater teal
Fingerprint reader cable
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the hard drive (see
Remove the fingerprint reader:
1. Remove the Phillips M2.0 × 3.0 screw (1) that secures the fingerprint reader bracket to the computer,
and then remove the bracket (2).
2. Disconnect the cable from the ZIF connector on the fingerprint reader board (3).
3. Remove the fingerprint reader from the computer (4).
Reverse this procedure to install the fingerprint reader.

USB board

To remove the USB board, use this procedure and illustration.
Table 5-8 USB board description and part number
Description
USB board
USB board cable
Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 34).
Hard drive on page 39).
Spare part number
M59357-001
M50424-001
32).
32).
Spare part number
M50413-001
M50422-001
Component replacement procedures 41