Wlan Module - HP 17-cn0 Series Maintenance And Service Manual

2. Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.

WLAN module

To remove the WLAN module, use this procedure and illustration.
Table 5-5 WLAN module descriptions and part numbers
Description
Intel Wi-Fi 6 AX201 802.11ax (2 × 2) and Bluetooth 5 (non-vPro)
Realtek 802.11b/g/n/a/ac (2 × 2) MU-MIMO supported and Bluetooth 5
Realtek RTL8821CE 802.11b/g/n/a/ac (1 × 1) MU-MIMO supported and Bluetooth 4.2 combo
Realtek Wi-Fi 6 RTL8852AE-VT + Bluetooth 5.2
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the WLAN module:
1. Remove the tape that covers the antenna connectors on the WLAN module (1).
2. Carefully disconnect the two antenna cables from the module (2).
38 Chapter 5 Removal and replacement procedures for authorized service provider parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Bottom cover and rubber feet on page
Battery on page
Preparation for disassembly on page
34).
Spare part number
L92724-005
L44796-005
M09870-005
M34029-005
32).
32).