Power Connector Cable - HP OMEN X Maintenance And Service Manual

Power connector cable

Table 6-5 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery (see
4. Remove the heat sink/fan assembly (see
Remove the power connector cable:
1. Disconnect the cable from the system board (1).
2. Remove the two Phillips M2.0 × 5.5 screws (2) that secure the bracket to the computer, and then remove
the bracket (3).
3. Remove the power connector and cable from the computer (4).
Reverse this procedure to install the power connector cable.
(Preparation for disassembly on page
Bottom cover on page
Battery and speakers on page
Heat sink/fan assembly on page
26).
27).
32).
35).
Component replacement procedures
Spare part number
L57017-001
39