2.
Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.
NOTE:
Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-5
Memory module descriptions and part numbers
Description
Memory module, 8 GB (DDR4-3200)
Memory module, 4 GB (DDR4-3200)
Before removing the memory, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover
3.
Remove the battery (see
If you are replacing a memory module, remove the existing memory module:
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
▲
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
Do not touch the components on the memory module.
(Preparation for disassembly on page
(Bottom cover on page
Battery on page
To prevent damage to the memory module, hold the memory module by the edges only.
27).
29).
Component replacement procedures
Spare part number
L46598-005
L83673-005
27).
33