Solid-State Drive - HP Pavilion 15 Maintenance And Service Manual

3. If the WLAN antenna is not connected to the terminal on the WLAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-4 Solid-state drive descriptions and part numbers
Description
1 TB, PCIe
1 TB solid-state drive + 32 GB Optane memory
512 GB, PCIe
512 GB solid-state drive + 32 GB Optane memory
256 GB, PCIe
256 GB solid-state drive + 16 GB Optane memory
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the drive to the computer.
32 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 27).
Battery on page 29).
Spare part number
L85370-005
L85374-005
L85364-005
L85366-005
L85354-005
L85356-005
L85346-005
27).