Safety; Regulatory Compliances - Vaisala CARBOCAP GMW80 Series Quick Manual

In GMW87M, the component board is located on the cover of the enclosure. Wires are led into
the enclosure either through a cable gland on the bottom of the mounting base or a sealed
lead-through at the back. The enclosure is opened and closed with 4 screws.

Safety

The GMW87M transmitter delivered to you has been tested for safety and approved as shipped
from the factory. Note the following precautions:
WARNING!
CAUTION!
documentation. Improper modification or use may lead to safety hazards,
equipment damage, failure to perform according to specification, or decreased
equipment lifetime.
CAUTION!
damage to electronic circuits. Avoid touching exposed component contacts
during installation and maintenance.

Regulatory compliances

Vaisala GMW80 series transmitters are in conformity with the provisions of the following EU
directives:
• RoHS Directive
• EMC Directive
The conformity is declared with using the following standards:
• EN 50581: Technical documentation for the assessment of electrical and electronic
products with respect to the restriction of hazardous substances.
• EN 61326-1: Electrical equipment for measurement, control, and laboratory use – EMC
requirements – Immunity test requirements for equipment intended to be used in an
industrial electromagnetic environment.
• EN 55032: Information technology equipment – Radio disturbance characteristics – Limits
and methods of measurement.
4
Make sure that you prepare or connect only de-energized wires.
Do not modify the unit or use it in ways not described in the
Electrostatic Discharge (ESD) can cause immediate or latent
M212445EN-A