Immergas CAR V2 Wireless Instruction And Warning Book page 9

N.B: for correct installation prepare a dedicated line for
the connection of the Base according to the Standards in
force regarding electrical systems. If this is not possible,
interference due to other electric cables could cause the
Base to malfunction.
4) Fasten the lid of the CAR
engaging it using pressure (Fig. 1-5).
N.B.: when closing the lid, make sure it is aligned correctly
with the bottom.
6) Separate the fixing template from the body of the CAR
using a screwdriver as a lever in the relative recess (Fig.
1-8). Install the CAR
V2
suitable position to detect the room temperature correctly
(Fig. 1-6 and 1-7).
7) Install the CAR using the openings on its rear part
V2
directly onto the wall or on a recess box using the relative
supplied screws.
8) Fasten the body of the CAR
engaging it with pressure and using the two screws
supplied (Fig. 1-8).
Base to the support bottom,
V2
away from heat sources and in a
to the support template,
V2
9) Insert 2 1.5 V AA batteries (not supplied) into the pre-set
housing (Fig. 1-8) and close the battery compartment.
10) The Base and the CAR
during the testing phase in the factory. Therefore, an
additional radio frequency association procedure is not
necessary.
V2
are associated to each other
V2
OK
NO
Fig. 1-6
Fig. 1-7
9