Indication / Contraindication - Drive Roomba Operation Manual

Indication / Contraindication

Walking device – for indoor and outdoor use – for
compensation and improvement respectively of
restricted ability of walking.
The purpose of walking devices is to compensate
for or at least improve restricted walking ability in
users (expansion of range and/or mobility).
Persons with restricted hand/arm functions require
special adjustments/versions of handgrips or hand
rests/armrests.
Impaired balance can be accommodated through
appropriate safeguards on the base of the walking
device.
Installation intructions
Height adjustment handgrips
Take the C-cap out, draw the handle tube up and
to the desire height. As Figure 1. Insert the C-cap
though the hole. (see Figure 2).
NOTE: Refer to the INSTALLATION WARNINGS in
the SAFETY SUMMARY of this instruction sheet.
1
Opening / folding the rollator
NOTE: Refer to the FOLDING/ASSEMBLY WARN-
INGS in the SAFETY SUMMARY of this instruction
sheet. The figures are without bag for best view.
3
2
Opening
Support the front oft the tray with one hand and lift
the walker handle upwards, pull the tray tot he direc-
tion as Figure 3. The tray is completely open with a
clear "click".
To ensure it is fully open, support the handle with
one hand and press down on the tray with the other
hand (Figure 3). The rollator is completely opened
for use with a clear "click".
Folding
Grasp the tray folding bar and lift it up to release the
tray and fold down. (See Figure 4).
Grasp the handle with one hand and front wheel
bar center with another, drag the rollator folding bar
with the left fingers to lift. When reaching the highest
point, push the front wheel bar to fold it.
4
Bracke lock
Brake bar
Front wheel bar
Rollator
folding bar
Using brakes
Grasp both handles, press on the "red brake lock"
to lock the rollator and it is well locked with a clear
"click". Press on the "red brake lock" to unlock and it
is unlocked with a clear "click". (See Figure 4).
Using Tray
Ensure the tray is installed with the rollator before us-
ing. If not installed, follow the steps to re-fit it.
Support the tray with both hands on the tray locks
(see Parts of walking device Nr. 12) and lift them un-
til the tray is in place, then gently press them down
when the tray corners touch the columns on the
bracket.
Ensure the component connects tightly on the sup-
porting tube above the bag.
Ensure the tray corner touch the columns lightly to
avoid damage of the columns. Otherwise it will de-
stroy the function of the tray locks and lift the tray
lock on the bracket to unlock them. Then take the
tray out by lifting up flatly.
EN
Handle
Tray folding bar
5