Table of Contents
Advertisement
To allow the correct functioning of the dehumidifiers, it's important to grant a constant air flow to the unit. This flow
must be close to the nominal value (see the drawing). The maximum tolerance allowed is 20%. .
The installer will take care to verify, during the start-up, the air flow to the unit and modify, if necessary, the speed
of the fans.
If the air speed through the evaporating coil exceed the 1,5÷2 m/s, the dehumidification capacity of the unit is strongly
reduced and the required environmental conditions can be compromised.
Speed wired in factory.
4.15 Remote mechanical hygrostat connection (HYGR.30)
Summer/Winter
switch
(not supplied)
ø
ø
ø
ø
Summer
ø
Winter
24
Hygrostat
Common
HYGRO-THERMOSTAT
100
90
35
80
40
70
50
60
I
0
°C
20
25
15
30
10
35
Advertisement
Table of Contents
