Table of Contents
Advertisement
Pre-slice panel
4.10 Installation of dehumidifier into the formwork
The dehumidifier will be inserted in the formwork, possibly cutting the pre-slice placed in correspondence of the connections, in order to facilitate insertion.
The final attachment to the formwork will be carried out on the right and left sides with screws, using the holes provided.
4.11 Condensate draining connections
Condensate draining on dehumidifiers should be done with a rubber pipe passing fixed to a pipe fitting with an external diameter of 20 mm located on the
lateral panel. On the condensate discharge pipe it must be installed a syphon with a minimum height equal to the suction pressure of the fan.
4.12 Water coil hydraulic connection
The dehumidifier is connected to the cooled water plant to grant the inlet in ambient of air in neutral conditions. On the units GH-GHW the connection is
done using the female gas attacks ½" always present on the unit.
Formwork assembled
22
Special Bolts to fix grilles at site
supplied as standard.
Condensate drain
Power supply
Hydraulic connections
Advertisement
Table of Contents
