Infrared Sensor Board Cable - HP Spectre x360 14 Maintenance And Service Manual

2. Remove the infrared sensor board (2).
Reverse this procedure to install the infrared sensor board.

Infrared sensor board cable

To remove the infrared sensor board cable, use this procedure and illustration.
The infrared sensor board cable is available using spare part number M22151-001.
Before removing the infrared sensor board cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
1. Battery (see
2. System board (see
3. Infrared sensor board (see
Remove the infrared sensor board cable:
1. Turn the infrared sensor board right side up with the cable away from you.
2. Release the ZIF connector (1) to which the infrared sensor board cable is connected, and then disconnect
the infrared sensor board cable from the infrared sensor board.
54 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 38)
System board on page
Infrared sensor board on page
37), and then remove the following components:
46)
53)
37).
ENWW