Connector Board - HP Spectre x360 14 Maintenance And Service Manual

3. Remove the battery (see
4. Remove the system board (see
Remove the connector board cable:
1. Release the ZIF connector (1) to which the connector board cable is connected, and then disconnect the
connector board cable from the connector board.
2. Remove the connector board cable (2).
Reverse this procedure to install the connector board cable.

Connector board

To remove the connector board, use this procedure and illustration.
Table 5-9 Connector board description and part number
Description
Connector board
NOTE: The connector board spare part kit does not include the connector board cable. The connector board cable is available usiung
spare part number M22150-001.
Before removing the connector board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
4. Remove the system board (see
Remove the connector board:
ENWW
Battery on page 38).
System board on page
(Preparation for disassembly on page
(Bottom cover on page 37).
Battery on page 38).
System board on page
46).
37).
46).
Component replacement procedures
Spare part number
M22163-001
51