Fan/Heat Sink Assembly - HP Spectre x360 14 Maintenance And Service Manual

10. Remove the system board (4) by sliding it up and forward at an angle.
Reverse this procedure to install the system board.

Fan/heat sink assembly

To remove the fan/heat sink assembly, use these procedures and illustrations.
Table 5-8 Fan/heat sink assembly descriptions and part numbers
Description
NOTE: The fan/heat sink assembly spare kit includes replacement thermal material.
For use only on computer models equipped with an OLED display assembly
For use only on computer models equipped with a WLED display assembly
Before removing the fan/heat sink assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
4. Remove the system board (see
Remove the fan/heat sink assembly:
1. Remove the fan shields (2 locations) (1) that secure the fan cables to the system board.
The fan shields are included in the Fan Shield Kit, spare part number M22153-001.
2. Disconnect the fan cables (2 locations) (2) from the system board.
3. Remove the six Phillips M2.0 × 2.0 screws (3) that secure the fan/heat sink assembly to the system board.
ENWW
(Preparation for disassembly on page
(Bottom cover on page 37).
Battery on page 38).
System board on page
37).
46).
Component replacement procedures
Spare part number
M22181-001
M22180-001
49