HP Spectre x360 14 Maintenance And Service Manual page 54

6. Detach the connector board cable (14) from the top cover. (The connector board cable is attached to the
top cover in two locations with double-sided adhesive.)
7. Remove the six Phillips M2.0 × 2.0 screws (1) that secure the system board to the top cover.
8. Remove the two Phillips M2.0 × 4.1 screws (2) that secure the system board to the top cover.
9. Lift the front edge of the system board (1) until it rests at an angle.
NOTE:
through the opening in the system board.
NOTE:
from the opening in the top cover.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
When removing the system board, be sure that the infrared system board cable (2) routes cleanly
When removing the system board, be sure that the USB Typc-C connector (3) releases cleanly
ENWW