HP Spectre x360 14 Maintenance And Service Manual page 47

Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Use the notch (1) in the side of the solid-state drive shield to remove the shield (2).
2. Remove the solid-state drive by sliding it away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
ENWW
(Preparation for disassembly on page
(Bottom cover on page 37).
37).
Battery on page 38).
Component replacement procedures 41