Allocate Address; Load To Device; Load To Pg/Pc; Read Maintenance Information - Siemens PROFIBUS PA SIPART PS2 Manual

Care and Maintenance
5.2.1.1

Allocate address

5.2.1.2

Load to device

and
5.2.1.3

Load to PG/PC

5.2.1.4

Read maintenance information

120
With SIMATIC PDM the process device data can be
displayed,
S
adjusted,
S
changed,
S
compared,
S
checked for plausibility
S
administered and
S
simulated
S
In general, we recommend the following procedure:
First of all read the current settings from the device, by initiating the
S
action "Load to PG/PC",
Check the current settings,
S
Check the required settings,
S
Load the parameter settings into the device and also save the pa-
S
rameter settings offline.
In the PDM menu bar there are menu headers File, Device, View, Ex-
tras and Help. In the following description the device menu will be de-
scribed in detail. Under these headers there are further sub-menus.
Here the positioner can be allocated a new address. Note that this can
only be done if the slave is not yet in cyclical operation.
These can be performed simply by clicking on the respective symbol
(Icon) in the menu bar.
" Load at PG/PC " allows the parameters of the positioner to be read,
changed as necessary and then using " Load to device " sent to the
positioner.
This gives information regarding the current values set during the last
initialization of the positioner. By comparing them with reference values
the values set during the last maintenance can be saved and the status
of the fitting assessed.
.
SIPART PS2 PA Manual
A5E00127926-03