Touchpad Click Board - HP 14s Maintenance And Service Manual

Touchpad click board

Table 5-10 Touchpad click board description and part number
Description
Touchpad click board
NOTE: The touchpad click board spare part kit does not include the cable. The cable is available as
spare part number L24485-001.
Before removing the touchpad click board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad click board:
1. Disconnect the touchpad click board cable from the ZIF connector on the touchpad click board (1).
2. Disconnect the touchpad board cable from the ZIF connector on the touchpad click board (2).
3. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer, and
then remove the board (4).
Reverse this procedure to install the touchpad click board.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 25).
22).
23).
Component replacement procedures
Spare part number
M05046-001
39