Usb, Card Reader, And Power Button Board - HP 14s Maintenance And Service Manual

USB, card reader, and power button board

Table 5-7 USB, card reader, and power button board description and part number
Description
USB, card reader, and power button board
NOTE: The USB, card reader, and power button board spare part kit does not include the cable. The
cable is available as spare part number L23186-001.
Before removing the USB, card reader, and power button board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the USB, card reader, and power button board:
1. Disconnect the cable from the ZIF connector on the board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the board to the computer.
3. Move the antenna cable that routes across the board (3).
4. Remove the board from the computer (4).
Reverse this procedure to install the USB, card reader, and power button board.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 25).
22).
23).
Component replacement procedures
Spare part number
M05045-001
35