Immergas SUPER TRIO Instructions And Warnings page 13

Magis Pro - Magis Pro V2 Internal
Unit installation operations.
• Tighten the bracket (H) to the special
upper cross member with screws (F).
• Hang the Internal Unit (G) on the
bracket (H) installed previously,
(Fig. 11).
G
• Make the hydraulic connection
between the storage tank (a), single
zone hydronic unit (c) and Magis Pro
- Magis Pro V2 Internal Unit (G), as
shown in Fig. 12 and 13.
Perform the connections in sequence,
starting from the pipes near the rear
wall up to those near the installer,
H
1
F
2
13
remembering to insert the special
gaskets supplied.
N.B. (Fig. 13): remove the grid from
the Magis Pro - Magis Pro V2 Internal
Unit and connect the shut-off valves on
the return of the same to the relative
pipe in the accessory kit.
1
F
G
2
1
2
Key:
1 - Supplied in the kit
2 - Present in Magis Pro - Magis Pro
V2
11
12